HP Hitachi Dynamic Link Manager Software - Manual (Page 384)

368 Chapter 9 Messages
9.16 Return Codes for the HDLM Remote Access Interface
The HDLM remote access interface is an interface used by other HiCommand products to
access hosts. HDLM outputs a return code when the operation that the HDLM remote access
interface requested to HDLM terminates abnormally, or when there is a warning while the
operation terminates normally.
Return Code Details and Actions
1002 Details
There is no path on which the operation can be performed.
Action
Refresh the host information, check the path status, and then perform the operation again.
1003 Details
No path was detected.
Action
Check whether a path between the host and the storage system is connected. If a path is
connected, check whether HDLM is configured correctly.
1004 Details
Memory required for HDLM internal processing could not be allocated.
Action
Terminate unnecessary applications to increase free memory, or restart the host.
1006 Details
The Offline path cannot be placed Online.
Action
Remove the error in the path, and then retry.
1007 Details
The target path of the offline operation is the last path of the device and cannot be placed in the
offline status.
Action
Click Refresh to update the host information, check the path status, and then retry the offline
operation.
1015 Details
The Offline path cannot be placed Online.
Action
Remove the error in the path, and then retry.
1016 Details
The target path(s) are already Online.
Action
Update the host information, and then check the path status.
1017 Details
The target path(s) are already Offline(C).
Action
Update the host information, and then check the path status.