HP Hitachi Dynamic Link Manager Software - Manual (Page 119)

HiCommand ® Dynamic Link Manager (HDLM) for Windows ® Systems User’s Guide 103
3.6.3.4 Performing a New Installation Using Oracle RAC
1. Shut down all the hosts.
2. Make sure that all the hosts comprising the cluster system have been fully shut down.
3. Start the host individually in the single path configuration.
4. Log on to Windows as a member of the administrators group.
5. Store the license key file directly under the Windows installation-destination drive. You
can also specify the license key directly without using the license key file.
installation-drive:\hdlm_license
The license key file will be deleted when the installation finishes.
6. Perform the installation.
– If you do not want to perform an unattended installation, insert the CD-ROM into the
drive, and start the installation program setup.exe.
The program checks whether HDLM has already been installed. If HDLM 5.4 or earlier
has been installed, the KAPL09129-E message appears. In this case, perform the
procedure shown in section 3.6.5. If HDLM 5.5 or later has been installed, the
KAPL09173-W message appears. In this case, perform the procedure shown in section
3.6.4. If no message appears, go to step 7.
– If you want to perform an unattended installation, insert the CD-ROM into the drive,
and start the installation program installhdlm.exe.
At the command prompt, execute the following command:
drive-to-which-the-installation-CD-ROM-is-
inserted:\DLMTools\installhdlm.exe -f installation-information-settings-
file (installhdlm.ini)
Specify n (do not restart) for the restart key in the installation-information
settings file.
This command checks whether HDLM has already been installed. If HDLM 5.4 or
earlier has been installed, the KAPL09129-E message appears. In this case, carry out
the procedure shown in section 3.6.5. If HDLM 5.5 or later has been installed, an
upgrade installation is performed, and then the KAPL09183-I message appears.
After the installation is complete, go to step 15.
7. The program checks the version of the MPIO driver, and then installs the MPIO driver. If
a message appears asking you whether you want to install the MPIO driver, follow the
procedure below:
– The KAPL09127-W message appears if MPIO driver has already been installed and its
version does not match the version of MPIO driver to be installed:
– Click the Next button to install MPIO driver.
– Click the Cancel button to cancel the installation.
– If no message appears, go to the next step.