HP Hitachi Dynamic Link Manager Software - Manual (Page 160)

144 Chapter 4 HDLM Operation
4.3.7 Viewing License Information
To display license information, execute the dlnkmgr command's view operation with the -
sys and -lic parameters specified. The following shows an example in which the command
is executed.
>dlnkmgr view -sys -lic
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name = view, completion
time = yyyy
/ mm / dd hh : mm : ss
>
For details on the displayed items and their descriptions, see section 7.7.
4.3.8 Updating the License
To update the license, execute the dlnkmgr command's set operation with the -lic
parameter specified. When the confirmation message is displayed, enter y to execute, or n
to cancel the command. If the license key file does not exist, a message asking you to enter
the license key appears, so enter the license key.
Note: When you use the dlnkmgr command's set operation with the -lic parameter to
install the license, you can only execute one command at a time. If you attempt to execute
more than one dlnkmgr command containing the set operation with the -lic parameter,
the following message might appear and HDLM might terminate abnormally:
KAPL01075-E A fatal error occurred in HDLM. The system environment is invalid.
If this message appears, execute the dlnkmgr command's view operation with the -sys -
lic parameter to make sure that the license is installed correctly. The following shows an
example in which the command is executed:
>dlnkmgr set -lic
KAPL01049-I Would you like to execute the operation? Operation name = set [y/n]: y
KAPL01071-I A permanent license was installed.
KAPL01001-I The HDLM command completed normally. Operation name = set, completion
time = yyyy
/ mm / dd hh : mm : ss
>