HP StorageWorks XP Remote Web Console Software - Manual (Page 107)

Continuous Access XP Journal user guide 107
• Volume: Number of data volumes registered in the mirror.
• Capacity: Total capacity of data volumes registered in the mirror.
• Previous: Displays detailed information about the previous journal group.
• Next: Displays detailed information about the next journal group.
• Close: Closes the JNL Group Detail pane.
Changing options for journal groups
If you are logged onto an XP10000, you can perform this operation only on journal groups that have a
number below 10.
To change a journal group’s options, the primary and secondary array administrators must perform the
following procedure:
1. Ensure that Command View XP or XP Remote Web Console is in Modify mode. For more information,
see the HP StorageWorks Command View XP user guide for XP Disk Arrays or the HP StorageWorks
XP Remote Web Console user guide for XP12000/XP10000/SVS200.
2. Display the Journal Operation pane (see ” Displaying the Journal Operation pane ” on page 95).
3. Do one of the following:
• In the tree, right-click a journal group from below Registered, and select JNL Groups and Change
JNL Option.
• In the upper-right list, right-click the desired journal group, and select JNL Groups and Change JNL
Option.
CAUTION: You can select Change JNL Option only when one of the following conditions is
satisfied:
• Journal group’s attribute is Initial.
• Journal group’s status is Stop.
• Journal group’s status is Active.
4. In the Change JNL Option pane ( Figure 48 ), change journal group options, and click Set.
CAUTION: If the journal group’s status is Active or if the master journal group’s status is Hold, you
can change only the Line of Speed option.
NOTE: If you selected two or more journal groups in step 3 and want to leave some options in the
Change JNL Options pane unchanged, specify blank for the options. If you specify blank for an
option, the option value remains unchanged. If you specify a value other than blank, the specified
value is set to the selected journal groups.
5. In the Preset list, check the settings you made.
• To modify a setting, right-click the setting in the Preset list, and select Modify.
• To cancel a setting, right-click the setting, and select Cancel.
6. Click Apply to apply the settings.