HP StorageWorks XP Remote Web Console Software - Manual (Page 126)

126 Performing Continuous Access XP Journal pair operations
NOTE: You cannot select more than one pair.
3. Select Pairdisplay.
4. In the Pairdisplay pane ( Figure 55 ), view detailed information about the pair.
5. Click Close.
Figure 55 Pairdisplay pane
• Status: Status of the pair. If the pair is split (or suspended), the column also displays the suspend type.
If the pair is waiting for initial copy, the column also displays Queuing.
• Alternative Path: Alternate path.
• Prog./Sync.: If the volume in the local array is a primary data volume, this column displays an initial
copy operation’s progress.
If the volume in the local array is a secondary data volume, this column displays the following
information:
• If the volume pair is not split, this column displays nothing.
• If the volume pair is split and, therefore, is in PSUS or PSUE status, this column usually displays the
synchronization rate (that is, concordance rate) between the secondary data volume before it was
split and the secondary data volume after it was split. For example, the synchronization rate is 100
percent if the contents of the secondary data volume is the same before and after the volume pair
was split.
CAUTION: If a failure in the initial copy operation causes the volume pair to be split, this column
displays nothing. If a failure occurs in the initial copy operation, the Pairdisplay pane displays
Initial copy failed.
In the following cases, this column is blank:
• When the volume in the local array is not a primary or secondary data volume.
• When the status of the volume pair is HOLD or HLDE.