Administering directory groups – HP Integrated Lights-Out 3 User Manual
Page 37
When you select iLO user privileges, the equivalent IPMI/DCMI user privilege is displayed in the
IPMI/DCMI Privilege based on above settings box.
•
User—A user has read-only access. A user cannot configure or write to iLO, or perform system
actions.
For IPMI User privileges: Disable all privileges. Any combination of privileges that does not
meet the Operator level is an IPMI User.
•
Operator—An operator can perform system actions, but cannot configure iLO or manage user
accounts.
For IPMI Operator privileges: Enable Remote Console Access, Virtual Power and Reset, and
Virtual Media. Any combination of privileges greater than Operator that does not meet the
Administrator level is an IPMI Operator.
•
Administrator—An administrator has read and write access to all features.
For IPMI Administrator privileges: Enable all privileges.
Administering directory groups
iLO enables you to view iLO groups and modify settings for those groups. You must have the
Configure iLO Settings privilege to add or edit directory groups. Use the Add/Edit Directory Group
page to add or edit iLO directory groups.
To add or edit a directory group:
1.
Navigate to the Administration
→User Administration page, as shown in
.
2.
Do one of the following:
•
Click New in the Directory Groups section.
•
Select a group in the Directory Groups section, and then click Edit.
The Add/Edit Directory Group page opens, as shown in
Managing iLO users by using the iLO web interface
37