Advantech INTRAC-305 - Manual (Page 78)

INSTALLATION INTRAC-305
Page 66 INTRAC-305 MANUAL - Issue 3.2 ©2011 Advantech Wireless
Installing the INTRAC-305 comprises mounting the Controller
in a 19” rack, connecting the controller to the Motor Control
Cabinet and to the positional resolvers.
The INTRAC-305 will need to be set-up for the antenna
system including antenna beamwidth, resolver type and
internal or external beacon receiver.
Note THE INTRAC-305 MUST NOT BE MOUNTED ONLY BY THE
FRONT PANEL LUGS.
IT MUST BE SUPPORTED ALONG ITS SIDES
Connections (general)
Before making connections between the INTRAC Controller
and the Motor Cabinet ensure that they are both isolated from
the power source.
Connect the cables between the Motor Cabinet and the
INTRAC.
There should be no earth connection between the INTRAC
and the Motor Cabinet.
All connections between the INTRAC and the Motor Cabinet
should be via multi twisted pair cables with individual pairs
screened or an overall screen.
THE SCREEN(S) SHOULD ONLY BE CONNECTED AT THE
INTRAC END.
WARNING
POSSIBLE LETHAL POTENTIALS EXIST WITHIN THIS EQUIPMENT
THE COVERS SHOULD NOT BE REMOVED EXCEPT BY QUALIFIED PERSONNEL.
SWITCH OFF POWER AND ISOLATE SUPPLY BEFORE REMOVING COVERS.
IF IT IS NECESSARY TO OPERATE THE EQUIPMENT WITH THE COVERS REMOVED FOR
SERVICING PURPOSES ALL NECESSARY PRECAUTIONS SHOULD BE TAKEN TO
PROTECT AGAINST ELECTRIC SHOCKS