HP Deskjet F2235 All-in-One Printer - Manual (Page 30)

TIP: To help prevent rips, wrinkles, and curled or bent edges, store all paper flat in
a resealable bag. If the paper is not stored properly, extreme changes in temperature
and humidity might result in curled paper that does not work well in the HP All-in-One.
To load photo paper in the input tray
1. Remove all paper from the input tray.
2. Insert the stack of photo paper into the far-right side of the input tray with the print
side or glossy side down and short edge forward. Slide the stack of photo paper
toward the product until it stops.
If you are using photo paper that has a tear-off tab, verify that the tab is pointing away
from the product.
TIP: For more help on loading small-size photo paper, refer to the guides
engraved in the base of the input tray for loading photo paper.
3. Slide the paper-width guide inward until it stops at the edge of the paper.
Do not overload the input tray; make sure the stack of paper fits within the input tray
and is no higher than the top of the paper-width guide.
For best results, set the paper type before copying or printing.
Related topics
• Recommended papers for printing and copying
• Change the print settings for the current job
• Set the copy paper type
Load index cards
You can load index cards into the input tray of the HP All-in-One to print notes, recipes,
and other text.
For best results, set the paper type before copying or printing.
NOTE: The HP All-in-One leaves a 1.2 cm (0.5 inch) border on one short edge.
Before printing many cards, print one test card to make sure that the border does not
crop your text.
Load paper 27
Loa
d
o
rig
in
als and load
paper