HP LaserJet Enterprise MFP M725 series - Manual (Page 216)

Configure IP network settings
Printer sharing disclaimer
HP does not support peer-to-peer networking, as the feature is a function of Microsoft operating systems
and not of the HP print drivers. Go to Microsoft at www.microsoft.com .
View or change network settings
Use the HP Embedded Web Server to view or change IP configuration settings.
1. Print a configuration page, and locate the IP address.
● If you are using IPv4, the IP address contains only digits. It has this format:
xxx.xxx.xxx.xxx
● If you are using IPv6, the IP address is a hexadecimal combination of characters and digits. It
has a format similar to this:
xxxx::xxxx:xxxx:xxxx:xxxx
2. To open the HP Embedded Web Server, type the IP address into the address line of a Web
browser.
3. Click the Networking tab to obtain network information. You can change settings as needed.
Manually configure IPv4 TCP/IP parameters from the control panel
Use the control-panel Administration menus to manually set an IPv4 address, subnet mask, and default
gateway.
1. From the Home screen on the product control panel, scroll to and touch the Administration button.
2. Open the following menus:
● Network Settings
● Jetdirect Menu
● TCP/IP
● IPV4 Settings
● Config Method
3. Select the Manual option, and then touch the Save button.
4. Open the Manual Settings menu.
202 Chapter 9 Manage the product ENWW