HP Deskjet 832c Printer - Manual (Page 68)

61
5
Getting Help When Things Go Wrong
Basic Troubleshooting
This chapter provides solutions to some problems that you may encounter while
using your HP DeskJet printer.
The chooser doesn’t show the printer
icon
If you open the Chooser and don’t see
the printer icon, you probably need to
install the appropriate printer software.
For instructions, go to “Install Printer
Software” on page 2.
Also, make sure the QuickDraw GX
software is turned off. You can remove it
from the Extensions folder or use the
Extensions Manager to turn it off.
Installation is unsuccessful
If a message tells you that installation
was not successful, make sure you turned
off virus-detection software as explained
on page 2.
The computer doesn’t recognize your
printer
If you have selected your HP Deskjet
printer icon in the Chooser but nothing
prints, or if you get a message that the
computer is unable to choose a printer,
one of the conditions in the following
may be the cause.
USB connection
A cable connection may be loose. To
make sure that the USB cable is securely
connected:
1 Unplug each end of the USB cable and
plug it back in.
2 Open the Chooser and select your
printer.
For detailed instructions on selecting
your printer in the Chooser, go to
“Choosing Your Printer” on page 11.
• You may be using the wrong printer
software. Make sure you installed the
software as described in “Install Printer
Software” on page 2, and that you
have selected the printer as described
in“Choosing Your Printer” on page 11.
• The printer may need to be reset. Turn
the printer off, count
to five, then turn it back on.
EtherTalk Network connection
A cable connection may be loose. To
make sure that all cables are securely
connected:
1 Make sure both the computer and
printer are connected to your
EtherTalk network.
2 Turn off the computer and the printer.
3 Unplug each end of the cable you
want to test.
4 Plug both ends of the cable back in.
C6411-90053_VeniceFixed.book Page 61 Monday, June 28, 1999 11:50 AM