GE GFDR480GFWW - Manual (Page 8)

8
Control settings.
Light (on some models)
Press the button to turn on the light in the
dryer.
Press the button again to turn the light off.
This only controls the light when the door is
shut.
NOTE: The light will turn off by itself after
one minute when the door is shut.
14
Volume
Alerts you that the cycle is complete. The beeper
will continue to sound every minute for the next
5 minutes, until the clothes have been removed.
The clothes should be removed when the beeper
goes off so wrinkles don’t set in.
Press Volume to select low, medium or high
volume, or to turn the beeper off.
Lock Control
You can lock the controls to prevent any
selections from being made. Or you can lock
or unlock the controls after you have started
a cycle.
Children cannot accidentally start the dryer by
touching buttons with this option selected.
To lock the dryer, press and hold the Lock
Control button for 3 seconds.
To unlock the dryer controls, press and hold
the Lock Control button for 3 seconds.
A sound is made to indicate the lock/unlock
status.
The indicator light above the button will
illuminate when the controls are locked.
NOTE: The Power button can still be used
when the machine is locked.
15
16
17 eMonitor (on some models)
The eMonitor lights display the relative
energy use of your selected cycle and options.
They are provided as an energy guide and
range from Good (1 light) to Better (5 lights).
Cycle (time), dryness level, temperature, and
additional tumble options can increase or
decrease your energy efficiency. Some cycles
will not provide a display.
18 Clean Filter Message
This message represents only a reminder and
does not always appear when the filter needs
cleaning. The filter should be cleaned after every
drying cycle is complete.
This message will disappear after the Start/
Pause button is pressed. Even though you may
have already cleaned the filter (before or after
the Power button has been pressed), the “Clean
Filter” message will still be displayed until the
Start/Pause button is activated.
19 Display
Displays the approximate time remaining until
the end of the cycle.
As the cycle begins, you will see an initial
approximate total cycle time in the display.
Then lights will “race” in the display. This
means the dryer is continuously monitoring
the amount of moisture in the load. The lights
will continue until the dryer senses a low level
of moisture in the load. At that point, the dryer
will calculate and display the approximate
time remaining.