American Fibertek SM9p - Manual (Page 113)

105
802.1x Configuration interface
System Configuration
After enabling the IEEE 802.1X function, you can configure the parameters of this
function.
1. IEEE 802.1x mode: .enable or disable 802.1x protocol.
2. Radius Server IP: set the Radius Server IP address.
3. Server Port: set the UDP destination port for authentication requests to the specified
Radius Server.
4. Accounting Port: set the UDP destination port for accounting requests to the
specified Radius Server.
5. Shared Key: set an encryption key for using during authentication sessions with the
specified radius server. This key must match the encryption key used on the Radius
Server.