American Fibertek SM9p - Manual (Page 29)

21
limit.
show bandwidth I Show interfaces
bandwidth control
switch(config)#interface
fastEthernet 2
switch(config-if)#show bandwidth
state
[Enable | Disable]
I Use the state interface
configuration
command to specify
the state mode of
operation for Ethernet
ports. Use the disable
form of this command
to disable the port.
switch(config)#interface
fastEthernet 2
(config-if)#state Disable
show interface
configuration
I show interface
configuration status
switch(config)#interface
fastEthernet 2
switch(config-if)#show interface
configuration
show interface status I show interface actual
status
switch(config)#interface
fastEthernet 2
(config-if)#show interface status
show interface
accounting
I show interface statistic
counter
switch(config)#interface
fastEthernet 2
(config-if)#show interface
accounting
no accounting I Clear interface
accounting information
switch(config)#interface
fastEthernet 2
switch(config-if)#no accounting
Trunk Commands Set
Netstar Commands Level Description Example
aggregator priority G Set port group system switch(config)#aggregator priority