American Fibertek SM9p - Manual (Page 52)

44
IP Configuration
You can configure the IP for the switch. The system has the default IP address. You can
re-configure or use the default value.
1. DHCP: disable or enable the DHCP client function. When DHCP function is enabling,
you don’t need to assign the IP address and subnet mask. The system will be
assigned the IP address from the local DHCP server.
2. IP Address: assign the switch IP address. The default IP is 192.168.1.77
3. Subnet Mask: assign the switch IP subnet mask.
4. Gateway: assign the switch gateway. The default value is 192.168.1.254
5. DNS1: Short for Domain Name Server an Internet service that translates domain
name into IP addresses. Because domain name are alphabetic, they're easier to
remember. The Internet is based on IP address . Every time you use a domain
name , therefore, a DNS service must translate the name into the corresponding IP
address. For example, the domain name www.net.com might translate to
192.168.1.1.
6. DNS2: The backup for DNS1. When the DNS1 cannot function, the DNS2 can replace
DNS1 immediately.
7. Select <Save> action to save the configuration.
[NOTE] Always restart the switch after finished the setup.