American Fibertek SM9p - Manual (Page 30)

22
[1~65535] priority 22
aggregator activityport
[Group ID]
[Port Numbers]
G Set activity port switch(config)#aggregator
activityport 2 2
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
G Assign a trunk group
with LACP active.
[GroupID] :1~3
[Port-list]:Member port
list, This parameter
could be a port
range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
[Workport]: The
amount of work ports,
this value could not be
less than zero or be
large than the amount
of member ports.
switch(config)#aggregator group
1 1-4 lacp workp 2
or
switch(config)#aggregator group
2 1,4,3 lacp workp 3
aggregator group
[GroupID] [Port-list]
nolacp
G Assign a static trunk
group.
[GroupID] :1~3
[Port-list]:Member port
list, This parameter
could be a port
range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
switch(config)#aggregator group
1 2-4 nolacp
or
switch(config)#aggregator group
1 3,1,2 nolacp
show aggregator
[Group-number]
P Show the information
of trunk group
switch#show aggregator 1
or
switch#show aggregator 2