EOTech CNVD-T3 Clip-On Night Vision Device - Thermal 3 - Manual (Page 19)

2-1
CHAPTER 2
OPERATING INSTRUCTIONS
SECTION I
PREPARATION FOR USE AND INSTALLATION
2.1 PREPARATION FOR USE
2.1.1 Unpacking the Equipment
. Before unpacking the
equipment, verify that all major components listed in Table
1—2 are present. Check the CNVD-T3 assembly to ensure
the following additional items are also included:
a. Battery Cap Assembly
b. Video Jack Plug
c. Objective Lens Cover (and straps)
d. Objective Lens Protective Ring
If any of the major components or items listed above are
missing, seek guidance from the equipment issuing
authority.
2.1.2 Inspection of the Equipment
. Before use, inspect all
pieces of equipment for any damage such as cracks, loose
parts, faulty cables, or other visible defects. If any damage
or defects are noted, seek guidance from the equipment
issuing authority.
2.2 BATTERY HANDLING
2.2.1 Battery Inspection
. Before installation, inspect the
batteries for any cracks, dents, leakage, or bulging. Never
install a defective battery in the CNVD-T3.