EOTech CNVD-T3 Clip-On Night Vision Device - Thermal 3 - Manual (Page 37)

2-19
Once selected, the following sub-menu will appear in the
eyepiece display:
Figure 2-15 Menu – Reticle Sub-Menu
2.13.5.1 If in ZOOM 2X mode, P2X will be displayed in lieu
of POS. Activating either of these sub-menu items allow for
adjusting the position of the reticle in the eyepiece display.
a. Adjustments are made using the UP / DOWN / LEFT
/ RIGHT buttons. When adjusting reticle position,
AZ (azimuth) and EL (elevation) values appear in
the eyepiece display as shown in Figure 2-16. The
numbers represent “clicks” of the reticle. Azimuth
and elevation values can rapidly be returned to 0 by
pressing the UP and DOWN buttons or the LEFT
and RIGHT buttons simultaneously.
b. When in ZOOM 1X mode, the reticle moves in 2-
pixel increments each time the UP / DOWN / LEFT /
RIGHT buttons are pressed. The reticle is moved in
1-pixel increments when in ZOOM 2X mode. See
section 2.16 for click equivalents and zeroing
information.
Figure 2-16 Reticle Position Adjustment
2.13.5.2 Activating the OFF sub-menu item turns the reticle
off. Turning the reticle back on is accomplished by selecting
the RET menu item from the Main Menu.
POS ADJ
AZ 8 L
EL 2 U
EXIT POS OFF