EOTech CNVD-T3 Clip-On Night Vision Device - Thermal 3 - Manual (Page 26)

2-8
Figure 2-5 CNVD-T3 Features and Controls (cont’d)
2.6 POWER
Pressing the POWER button will turn the unit on and
automatically initiate a calibration.
With the system powered on, the CNVD-T3 can be placed in
a Standby Mode by pressing and holding the MENU / ZOOM
button for about 3 seconds. Pressing any of the LEFT /
RIGHT / UP / DOWN buttons will reactivate the unit. Upon
“waking” from Standby Mode, the unit will retain all settings
entered by the operator prior to being placed in standby.
Standby Mode decreases power consumption by
approximately 10% by shutting off the eyepiece display.
NOTE
In Standby Mode, the CNVD-T3 will continue to
draw power that will eventually drain the batteries.
Objective Lens
Video Jack /
Jack Plug
Objective
Lens Cover