A&D ML-50 - Manual (Page 10)

8 MS-70 / MX-50 / MF-50 / ML-50
Caution for Heating (Drying).
When the drying temperature is set to 200°C and measurement is started, the
thermostat of the halogen lamp may work after 30 minutes. When the halogen lamp
has cooled down, the next measurement can be started. If necessary, change the
drying time and temperature.
When a measurement is started and the time passes one hour, the maximum
temperature is automatically regulated to 160°C for safety.
Operation to Stop Measurement
During measurement, the STOP key is always effective. If there is an error or danger,
press the STOP key.
2.3. After Use and Maintaining the Analyzer
Put dust cover on the analyzer after it is cool.
Clean the glass-housing carefully.
Clean fingerprints from the halogen lamp to keep
its life. Refer to "14.2.Replacement of the Halogen
Lamp".
Avoid mechanical shock to the analyzer.
Do not disassemble the analyzer.
Protect the analyzer from excessive dust.
Use the packing box (special container) to move
the analyzer.
Clean the analyzer with a lint free cloth that is
moistened with warm water and a mild detergent.
Do not use organic solvents to clean the analyzer.
Do not disassemble or remodel the analyzer.
Glass-housing
Halogen lamp
Glass housing
Screw
Screw