A&D ML-50 User Manual
Page 37
MS-70 / MX-50 / MF-50 / ML-50
35
Store Parameters and Finish the Operation
14. Press the
ENTER
key to store the new parameters of
the measurement program to program number 3.
Pressing the key, the weighing mode is automatically
displayed.
When PROG 3 is recalled, the settings can be used.
To cancel the new parameters and return to the
weighing mode, press the
RESET
key.
Timer Mode
Refer to page 33 for Standard Mode, Automatic Mode or Manual Mode
This explanation uses the following parameters and sample displays of MX-50.
Common
Items
Program
number ..........................................4 ( PROG 4 )
Analysis
mode ..............................................Timer mode (Symbol: U-t )
Drying
program
Heating pattern....................Ramp drying (
)
Final drying temperature.....160°C
Ramp time...........................5.0 minutes
Drying time ..........................10.0 minutes
Measurement
unit ..............................................Moisture content
Minimum scale value during measurement ..0.01 %
Minimum scale value of gram display...........0.001 g
Sample
quantity............................................Approximately 5 g
Data
memory
function ..................................Not used
1. Display gram unit (of the weighing mode).
Select a Program Number to Edit the Measurement Program
2. Press
the
PROGRAM
key and press the
↓
or
↑
key to select a program number.
3. Press
the
ENTER
key to use the number.
4. The analyzer displays
end
and returns to the
weighing mode.
Caution If the data memory function is active, the data
memory number (MEM) is displayed in place of the
program number (PROG).
% MOIST
D
/W
/D
PROG 1
0.000
g
PROG "4
end
PROG 4
0.000
g
Program number
Final drying temperature
Ramp time
Drying time
0.000
g
160°C
Gram display of
weighing mode