A&D ML-50 - Manual (Page 55)

MS-70 / MX-50 / MF-50 / ML-50 53
In Case of Format included Temperature Data (Function Table 5-d 1 )
The first 3 figures are the temperature data.
The format consists of nineteen characters except the terminator.
In case of the MS-70
In case of the MX-50 or MF-50
In case of the ML-50
10.3. Command
The analyzer can be controlled by the following commands from the computer.
Add a terminator ( 0Dh、0Ah ) to each command.
Command Description
Q Outputs the current data.
SIR Outputs data continuously
C Stops data output by SIR command.
QM Outputs the data during measurement. (In other mode, QM can not use.)
START Same as the START key
STOP Same as the STOP key
RESET Same as the RESET key
ENTER Same as the ENTER key
SELECT Same as the SELECT key
DOWN Same as the ↓ key
UP Same as the
↑
key
PROGRAM Same as the PROGRAM key
Header Moisture content Unit Terminator
160°C at sample pan
Header Moisture content Unit Terminator
160°C at sample pan
Header Moisture content Unit Terminator
160°C at sample pan