Turbo Action 70600 CHEETAH E-SHIFT Controller - Manual (Page 10)

10
Turn Function Switch knob clockwise one increment, until
the right LED position display reads 1. This position sets the
Race First Shift RPM to within 100 RPM Fig. #1.
Note: This
shift needs to be 200-300 RPM early on 3, 4 and 5 speed transmissions.
Factory Default = 9990 RPM (Fig. #1).
Program Position #1:
a. Push Reset Button: Display will read position
number only.
b. To set 1000 RPM’s: Push 1000’s Button till it reads
1-15 (1000-15000 RPM).
EXAMPLE: If you stop at the #6, it will read as shown
in Fig. #2.
c. To set 100 RPM’s: Push 100’s Button till it reads
0-9 (000-900 RPM).
EXAMPLE: If you stop at the #7, it will read as shown
in Fig. #3.
POSITION #1: Race First (1-2) Shift RPM
Race Mode -
Burn Out Mode -
Pit Road Mode -
Hold Mode -
CHEETAH E-SHIFT Controller
Programming for 4 Shifts
Your unit has been shipped with specific factory defaults which are changeable by you.
Programming Function Switch Positions 1 -15:
Turn power on to your CHEETAH E-SHIFT Controller, but do not start engine.
POSITION #0: Normal Running
Display reads Engine RPM
Display reads Burn
Display reads P._rd
Display reads Hold
9 9 9 1
10K 1K 100 POSITION
Fig. #1
6 0 0 1
10K 1K 100 POS. POS.
Fig. #2
6000 RPM
6 7 0 1
10K 1K 100 POS. POS.
Fig. #3
6700 RPM