Turbo Action 70600 CHEETAH E-SHIFT Controller - Manual (Page 3)

3
1535 Owens Road, Jacksonville, FL 32218 ~ Phone 904-741-4850 ~ FAX 904-741-4853
www.turboaction.com
CHEETAH E-SHIFT Controller
Part #70600
4 Shift Output
CAUTION: Do Not connect directly to a Magneto ignition system. You must use an
adapter available from Auto Meter, Race Pack, etc.
FIRST , READ INSTRUCTIONS CAREFULLY, THEN PROCEED TO INSTALL CONTROLLER BY FOLLOWING
EACH STEP INDIVIDUALLY.
Controller 1 - 70600 Controller
Kit Includes: 2 - U00780A Screw Connector Terminals
1 - U00792-1 Pit Road Switch, [Momentary On/Off (Normal)
(For Use with CHEETAH E-Shift Valve Bodies Only)
1 - Set of Instructions
2 - 50102 Contingency Decals
Warranty: Your unit from the date of purchase has a one full year factory warranty against factory defects, which
includes hardware and software problems. It must be understood that the warranty will not cover any
CHEETAH E-SHIFT Controller which has been wired improperly, including faulty current and voltage
input or output connections! This warranty applies to the original owner only.
STEP #1: Pick a location for your CHEETAH E-SHIFT Controller. Do Not install in the Engine Compartment or
within 12” of the Ignition Coil or it’s High Output Wire.
STEP #2: Dedenbear, Biondo, Etc. Electric Shifters require a high current relay. The CO2/Electric Shifters
normally do not. We suggest you use 14-16 gauge wire for all connections. If you are connecting to a
device drawing more than 5 Amps, use a high current relay, Turbo Action Part #5000-1, between the
CHEETAH E-SHIFT Controller and the device you wish to control. See special drawing for high
current relay hook up.
NOTE: All CHEETAH E-SHIFT Electronic Valve Bodies require 5 Amps or less to operate. Please check
with the manufacturer of your device on how much current it will draw before connection to our
CHEETAH E-SHIFT Controller.
STEP #3: When wiring your Controller, be sure wires are trimmed with approximately 1/4” - 5/16” of wire
showing. After trimming wire, twist wire tightly so there are no loose strands of wire.
CAUTION:
If stray wires accidentally touch other wires, you will cause a short and burn up your
Controller and or your RPM activated device.
STEP #4: It is suggested you fuse your Controller for an extra margin of safety. See Figure #1,#2,#3,#4 & #5
for proper connecting of your Controller.
STEP #5: The following information together with Fig. #1, #2, #3, #4 & #5 should make your wiring a simple
task.
01/18/02, 02/13/02,4/16/03
WILL NOT WORK PROPERLY WITH ODD FIRE V6!