Tuff Country 56900 - Toyota Tacoma 05-14 6 lift kit - Manual (Page 11)

37. Working on the driver side, install the lower control arm
using the stock cam sleeves and bolts. Repeat on passen-
ger side Special note: it is important that all previously
new installed hardware is not tight at this time to make
installing the control arms much easier. Do not tighten
cam bolts at this time
38. Locate the stock steering knuckles and remove (4) stock
bolts that hold the hub assembly to the knuckle, now remove
the hub assembly from the steering knuckle and set aside.
Next remove the metal dust shield from the knuckle.
39. Carefully remove the dust seal from both stock steering
knuckles. The stock knuckle may be discarded.
40. Carefully install the stock dust seal into the new steering
knuckles. Special note: Take extra special care to not
damage the seal during installation.
41. Install the metal dust shield onto the new steering knuck-
les followed by installing the hub assembly using the stock
hardware. Make sure to sue thread locker or loctite and
torque to 79 ft lbs.