Tuff Country 56900 - Toyota Tacoma 05-14 6 lift kit - Manual (Page 12)

42. Working on the driver side, remove the (2) stock bolts
that are holding the sway bar to the frame rail. Repeat on
passenger side and remove sway bar from vehicle. The
stock hardware may be discarded.
43. Locate the (2) new sway bar relocation brackets. Also
locate (4) 10 mm x 30 mm socket head screws, (4) 5/16”
USS flat washers and (4) 3/8” unitorque nuts from hardware
bag 56900NB bag # 1.
44. Working on the driver side, be sure to apply some thread
locker or loctite to the threads of the new 10 mm x 30 mm
bolts, now install the new sway bar relocation bracket mak-
ing sure that it is installed so that it moves the sway bar
towards the front of the vehicle. Repeat on passenger side.
Once the new
bolts are started,
make sure to
torque the 10 mm
bolts to 14 ft lbs.
45. Locate the stock sway bar. Install the sway bar onto the
new brackets using the new 5/16” USS flat washers and 3/8”
unitorque nuts. Do not tighten at this point.
46. Locate the stock strut assemblies and the stock upper
strut assemblies hardware. Also, locate the new upper strut
spacers. Install the new upper strut spacers on top of the
stock strut plate using the stock hardware. Make sure to use
thread locker or loctite and torque to 42 ft lbs.