Tuff Country 56900 - Toyota Tacoma 05-14 6 lift kit User Manual
Page 7
19. Working on the driver side, remove the front and rear
cam bolts that hold the lower control to the vehicle, now
remove the lower control arm and set aside. Save stock cam
bolts and sleeves. Repeat on passenger side.
20. Working on the driver side rear cross member, measure
4 1/4” from the CENTER of the slotted cam bolt hole over
towards the center of the vehicle and make a mark. Do the
same on the passenger side. Now place a jack underneath
the front differential housing to support it while the cut is
being made. Carefully cut completely through the rear cross
member using your mark as a reference. Special note: Tuff
Country does not recommend using a torch to make this
cut, Tuff Country recommends using a Sawzall or die
grinder to make
this cut. Also, be
careful not to
damage any sur-
rounding parts.
Below: passenger side.
21. After the 2 cuts have been made through the rear cross
member, remove the allen headed nut on the rear differen-
tial mount. Save the stock nut. Now remove the section of
rear cross member that has been cut and discard.