Tuff Country 56900 - Toyota Tacoma 05-14 6 lift kit - Manual (Page 9)

29. Locate the new driver side differential bracket and the (3)
stock bolts. Also, locate (3) 9/16” hardened u-bolt washers,
and (3) 9/16” lock washers from hardware bag 56900NB bag
# 1. Install the new bracket into the stock position on the front
differential. Special note: Do not tighten bolts at this time.
30. Locate the new passenger side differential bracket and
the (2) stock bolts. Also, locate (2) 9/16” harden washers and
(2) 9/16” lock washers from hardware bag 56900NB bag # 1.
Install the new bracket into the stock position on the front dif-
ferential. Special note: The photos below does not show
using the 9/16” hardened u-bolt washers, they DO need
to be used. Do not completely tighten bolts at this time.
31. Locate the new front cross member. Locate (2) 3/4” x 5”
bolts, (4) 3/4” flat washers and (2) 3/4” unitorqe nuts from
hardware bag 56900NB bag # 1. Also, locate (4) front over-
size laser cut washers from hardware bags 56900NB1.
Install the new front cross member using the new hardware.
Special note: Do not tighten bolts at this time.
32. Locate the new rear cross member. Locate (2) 1/2” x 5
1/2” bolts, (4) 7/16” USS flat washers and (2) 1/2” unitorque
nuts from hardware bag 56900NB bag # 2. Also, locate (4)
rear over-size laser cut washers from hardware bag
56900NB1. Install new cross member using new hardware
and make sure to install bolts so that the head of the bolt is
towards the rear of the vehicle. Special note: Do not tight-
en bolts at this time.