Tuff Country 56900 - Toyota Tacoma 05-14 6 lift kit User Manual
Page 15
56. Locate the new upper driver side differential breather
hose bracket from hardware bag 56900NB1. Also, locate (1)
5/16” x 3/4” bolt (3) 1/4” USS flat washers and (1) 5/16” uni-
torque nut from hardware bag 56900NB bag # 2. This brack-
et is used to space the stock steel breather hose bracket
upwards. Install the new bracket so that you use the stock
bolt with a new 1/4” USS flat washer spacing it from the dif-
ferential, then use the new 5/16” bolt and hardware to con-
nect the new bracket to the stock one.
57. Move to the lower control arm adjustable cam bolts and
tighten all 4 of them. Special note: The cam bolts will be
adjusted during the alignment process, so it is not criti-
cal where they are set until then. Make sure to tighten
both the driver and passenger side.
58. Working on the new front cross member hardware, add
some thread locker or loctite to the new 3/4” hardware and
torque to 145 ft lbs. Make sure to tighten both the driver
and passenger side.
59. Working on the new rear cross member hardware, add
some thread locker or loctite to the new 1/2” hardware and
torque to 85 ft lbs. Make sure to tighten both the driver
and the passenger side.