Tuff Country 56900 - Toyota Tacoma 05-14 6 lift kit - Manual (Page 14)

51. Locate the stock bump stops. Also, locate the (2) new
bump stop spacers. Thread the stock rubber bump stops into
the new spacer. Make sure to use thread locker or loctite.
52. Working on the driver side, install the new bump stop
spacer and bump stop in the stock location. Make sure to
use thread locker or loctite. Repeat on passenger side.
53. Working on the driver side, remove the sway bar end link
from the sway bar. Save the stock sway bar end link and the
stock hardware. Repeat on passenger side.
54. Working on the driver side, install the driver side end link
on the passenger side of the stock sway bar. Then install the
passenger side end link onto the driver side. Make sure to
use thread locker or loctite and torque to 32 ft lbs.
55. Working on the driver side, thread the lower stud of the
sway bar end link into the neck of the new steering knuckle,
you will need to use an allen wrench and turn it counter-
clockwise to install it. Special note: Tuff Country recom-
mends coating the threads of the sway bar end link with
Anti-seize in case it ever needs to be removed again.
Also, it is sometimes necessary to disconnect the top of
the sway bar end link from the sway bar to be able to
thread into the steering knuckle.