Avocent Access Router Cyclades-PR2000 - Manual (Page 32)

Cyclades-PR2000
32 Chapter 4 - Step-by-Step Instructions
Menu CONFIG=>INTERFACE=>SWAN=>ENCAPSULATION=>FRAME RELAY=><ESC>=>ADD DLCI
Parameter
Example Your Application
DLCI Number Sixteen. This number is supplied by the
Public Frame Relay network provider.
Frame Relay Address Map Static, which maps one IP address to this
DLCI.
IP Address 200.240.230.1
Enable Predictor
Compression Yes, if Cyclades routers are used on both
ends of the link and Predictor Compression
is enabled on both routers. This feature is
effective only for links running at speeds
under 2 Mbps.
Number of Bits for
Compression Sixteen when both routers are of the PR
line. Ten must be used if the other router is
a PathRouter.
FIGURE 4.14 DLC CONFIGURATION MENU PARAMETERS
STEP FIVE
Now that the central office’s LAN has been defined, a route must be added to tell the router that the remote
site’s LAN is at the other end of the line. Creating a static route is the simplest way to do this. Chapter 9 of the
Installation Manual explains static routes and other routing methods available in CyROS. Fill in the spaces in
Figure 4.15 with the values for your application.