Avocent Access Router Cyclades-PR2000 - Manual (Page 48)

Cyclades-PR2000
Chapter 7 Network Protocols
48
CHAPTER 7 NETWORK PROTOCOLS
The second step in most interface configurations is to choose which network protocol to use and assign values
to the relevant parameters. At least one of IP, Transparent Bridge, or IPX (optional, and discussed in chapter
13) must be activated. Use the information provided below to set the parameters for each interface. The
Ethernet network protocol menu includes IP bridging and is explained in chapter 5. The SWAN Network
Protocol Menu is given in figure 7.1. Note that this menu varies slightly for each interface. Specific information
on the options for each interface is provided in the CyROS Reference Guide in the chapter for the interface.
Config
Interface IP
Transparent
Bridge
Active
Interface Unnumbered/Numbered
Assign IP from Interface
Primary IP address
Subnet Mask
Secondary IP Address
Subnet Mask
IP MTU
NAT
ICMP Port
Incoming Rule List Name
Detailed Incoming IP Accounting
Outgoing Rule List Name
Detailed Outgoing IP Accounting
Routing of Broadcast Messages
Status
Port Priority
Incoming Rule List Name
Outgoing Rule List Name
Network Protocol SWAN
FIGURE 7.1 NETWORK PROTOCOL MENU TREE FOR THE SWAN INTERFACE