Avocent Access Router Cyclades-PR2000 - Manual (Page 66)

Cyclades-PR2000
Chapter 9 - Routing Protocols 66
Unnumbered
Interfaces
Point-to-Point
Connection
Slot 1
ETH0
ETH0
Slot 3
Router 1
10.0.0.3
192.168.100.1
Router 2
A
B
E
F
Network 3
Network 1
FIGURE 9.2 STATIC ROUTING EXAMPLE 2
Figure 9.2 shows another static routing example to explain the Gateway or Interface parameter. Between the two
routers is a point-to-point connection. Another network could be created, but is not necessary. Both routers can
be assigned unnumbered interfaces, because everything that leaves one router is sent to the other.
To define static routes, enter the menu CONFIG =>STATIC ROUTES =>IP =>ADD ROUTE. A description of the
parameters in this menu, with the configuration for Router 1 in the examples above, is given in the table that
follows.