Avocent Access Router Cyclades-PR2000 - Manual (Page 44)

Cyclades-PR2000
Chapter 5 - Configuration of the Ethernet Interface 44
Network Protocol Menu (Continued) -- (IP Bridge)
Parameter Description
IP Bridge Activates the IP Bridge functionality.
The following parameters apply only if IP Bridge is Active.
Initial IP Address to
be Bridged Indicates the start of the range of IP addresses to be transferred to another physical
location. This and the next three parameters are repeated in case the bridge is to be
broken up into various sections. Up to 8 sections can be defined. In the example, this
value is 200.240.240.4.
Ending IP Address to
be Bridged Indicates the end of the range of IP addresses to be transferred to another physical
location. In the example, this value is 200.240.240.8.
Broadcast Over the
Link Allows propagation of broadcast IP packets over this bridge.
Bridge Over Link Indicates which link forms the other half of the bridge. In the example, link 1 is used.
Other Parameters
Transparent Bridge is covered in chapter 7 and IPX is covered in chapter 13. The parameters defined in the
Routing Protocol and Traffic Control Menus should be set after reading chapters 9 and 12, respectively. It is
probably best to complete the basic configuration of all router interfaces, then return to the routing protocol and
traffic control menus after general routing and traffic control strategies have been defined.