Avocent Access Router Cyclades-PR2000 - Manual (Page 47)

Chapter 6 - The SWAN and Async Interfaces 47
Cyclades-PR2000
STEP FOUR
If PPP Encapsulation is being used, a type of authentication should be chosen. This is done in the
authentication menu.
Authentication Menu CONFIG=>INTERFACE=>SWAN=>AUTHENTICATION
Parameter Description
Authentication Type Local uses the list of users defined in CONFIG=> SECURITY=>USERS=>ADD.
Server uses either Radius or Tacacs to authenticate the user.
Remote is when this interface is considered to be the user and the other end of the
connection performs the authentication
Username Applies when Authentication Type is Remote. The username the remote device
expects to receive.
Password Applies when Authentication Type is Remote. The password the remote device
expects to receive.
Authentication Server Applies when Authentication Type is Server. Indicates that either a Radius or Tacacs
server is used for validation. The location and other parameters of the server must be
configured in CONFIG=> SECURITY. See section 4.3 of the CyROS Reference
Guide.
Authentication
Protocol Applies when Authentication Type is Local or Server. Either PAP or CHAP or both can
be used for authentication.
STEP FIVE
The parameters defined in the Routing Protocol and Traffic Control Menus should be set after reading chapters
9 and 12, respectively. It is probably best to complete the basic configuration of all router interfaces, then
return to the routing protocol and traffic control menus after general routing and traffic control strategies have
been defined.