Chatsworth Products KVM Over IP - Manual (Page 48)

48
o Primary DNS Server IP Address: IP address of the primary Domain Name Server in
dot notation. This option may be left empty, however the IP console will not be able to
perform name resolution.
o Secondary DNS Server IP Address: IP address of the secondary Domain Name
Server in dot notation. It will be used in case the Primary DNS Server cannot be
contacted.
• Network Miscellaneous Settings
o Remote Console and HTTPS port: Port number at which the IP console's Remote
Console server and HTTPS server are listening. If left empty the default value will be
used.
o HTTP port: Port number at which the IP console's HTTP server is listening. If left empty
the default value will be used.
o Telnet port: Port number at which the IP console's Telnet server is listening. If left
empty the default value will be used.
o Bandwidth limitation: The maximum network traffic generated through the IP consoles
Ethernet device. Value in Kbit/s.
o Enable Telnet access: Set this option to allow accessing the IP console using the
Telnet Gateway, see section 3.1.2, Telnet Console.
o Disable Setup Protocol: Enable this option to exclude the IP console from the setup
protocol. Setup protocol is a proprietary layer-2 MAC-based protocol to allow some
configuration software to detect IP consoles in the network, even without IP address,
and then config network related settings to IP console.
o LAN Interface Settings: The “Autodetect” will set the Ethernet speed to the fastest
possible value supported by both endpoints of the link. For example, if you use a
10M/half duplex HUB, this speed will be auto-selected. If this option does not work with
some network device (HUB, switches, and routers), you can set the Ethernet interface
speed of IP console manually to the values as supported by the network device.