Chatsworth Products KVM Over IP User Manual
Page 61
61
1. The new firmware file is uploaded onto the IP console. In order to do that you need to select
the file on your local system using the button “Browse” of the Upload Firmware panel. Once
the firmware file has been uploaded, it is checked whether it is a valid firmware file and
whether there were any transmission errors. In case of any error the Upload Firmware
function will be aborted.
Update Firmware
2. If everything went well, you see the Update Firmware panel. The panel shows you the
version number of the currently running firmware and the version number of the uploaded
firmware. Pressing the button “Update” will store the new version and substitute the old one
completely.
Warning!
This process is not reversible and might take some minutes. Make sure
the IP console's power supply will not be interrupted during the update
process, because this may cause an unusable card.
3. After the firmware has been stored, the panel will request you to reset the IP console
manually, see section 3.7.4. Half a minute after the reset, the IP console will run with the
new firmware version and should be accessible. However, you are requested to login once
again.