Axis Communications 2460 - Manual (Page 63)

AXIS 2460 User’s Manual Installing Hard Disks 63
7. Replace the cover and screw it back into place. Set the main power switch to I. The
AXIS 2460 will now automatically detect and format the new disk(s).
Note: If the disk you installed has been used previously (a valid partition table will be detected), it will
not be formatted. In this case the disk must be formatted manually, either by selecting
Clean
from the Maintenance menu, which formats all the connected disks, or by formatting the indi-
vidual disk from the Maintenance - Advanced menu.
Any disk errors in the AXIS 2460 are indicated by the Disk LED on the front panel. This
will flash red if one of several installed disks is not functioning, and it will show a solid red
if none of the disks are functioning.