Aquacal Pool Pilot 75003 - Manual (Page 23)

INSTALLATION
17
Before Installing the #75001 Pool Pilot Pool Chemistry Controller System or
the #75004, #75005, #75006, or #75007 pH Acid Feed Pump and Tank System
• Determine that everything needed for installation is on hand
• Find a suitable mounting location for the Pool Chemistry Controller Unit within proper cord length to the Digital Control
Unit
• Find a suitable mounting location for the Stenner acid feeder and tank.
• Plan tubing runs for Flow Cell water sample tubing and Acid Feed lines
• For optional #75008 pH Auxiliary Relay Kit, plan for electrical connections
What is included?
Before attempting the Total Control installation, check that the following items have been included with the Pool Chemistry
Controller:
Quantity Item Description
1 #75001 Pool Chemistry Control unit with Flow cell, flow
switch, and interface cable
1 ORP sensor (in storage cap)
1 pH sensor (in storage cap)
1 Total Control interface cable
1 Mounting Template
4 Plastic Mounting Wall Anchors
4 Mounting Screws
16’ (5.3 m) 3/8” Water Sample tubing
2 Injection Fitting with gasket and S.S. saddle clamp
1 In-line check valve adapter fitting
Before attempting the pH Acid Feed Pump and Tank Kit installation, check that the following items have been included with the
pH Control System:
For #75008 Auxiliary Relay Kit
Quantity Item Description
1 Auxiliary Relay box with internal relay and interface cable
4 Plastic Mounting Wall Anchors
4 Mounting Screws
What is not included
Some of the additional equipment that is needed to complete the installation:
• Drill with 3/8” bit
• Utility Knife
For installations using Stenner Factory Tube and Fittings
• ¼” NPT drill and tap kit
• Teflon Tape
For #75008 auxiliary relay kit
• Appropriate gauge electrical wire
• ½”liquidtite (non-metallic flex) conduit
• ½” conduit connector for service to the Pool Pilot Digital Control unit
Quantity Item Description
1 Stenner pH acid feed pump with 15 gallon acid tank
1 Injection Fitting with gasket and S.S. saddle clamp
1 In-line check valve adapter fitting
8’ (2.7 m) 1/8” ID x ¼” OD tubing
1 Cable Clamp and Nut assembly
1 pkg Stenner Factory Parts Kit (fittings and components)