Avaya IP OFFICE 40DHB0002USCL - Manual (Page 48)

Page 48 - Wall Mounting 2000 Series Telephones Telephone Installation
Wall Mounting 2000 Series Telephones
Mounting brackets exist which clip onto the base on IP Office telephones. These brackets (two
required per telephone) can be used to either raise the desk position of the telephone or for wall
mounting. Before wall mounting a telephone, check that the surface is flat, vertical and not subject to
movement or vibration.
To wall mount an IP Office telephone :
1. Using the dimensions given below, mark the position for the screw holes. Ensure that adequate
clearance above and below the telephone is allowed.
2. Drill the necessary holes and insert the wall plugs.
3. Insert the screws, leaving the heads approximately 3mm proud of the surface (check by clipping a
bracket over the screw head).
4. Attach the brackets to the telephone. Then slide the bracket key-slots over the screw-heads.
5. Reverse the position of the handset retainer tab (located below the hook switch on the telephone).
This keeps the handset in place whilst the telephone is mounted on the wall.
Additional Items :
– Two No. 8 Pan head or
Round head screws.
– Two wall plugs.
– Drill and drill bit.
– Screwdriver. IP Office 2030/50 Telephones
(Not to scale)
IP Office 2010 , IP Office 20AT
Telephones (Not to scale)
Page 48 - Telephone Installation IP Office Installation Manual
Wall Mounting 2000 Series Telephones 40DHB0002USCL – Issue 7 (09/25/2002)