Regulatory instructions for use, Ip office operation in australia, Ip office operation in canada – Avaya IP OFFICE 40DHB0002USCL User Manual

Page 8: Industry canada notification (doc)

Advertising
background image

Page 8 - Regulatory Instructions for Use

Safety and Homologation Statements

Regulatory Instructions for Use

IP Office Operation in Australia

Connection
Connection of IP400 Office products must be via a Line Isolation Unit with a telecommunications

compliance label.
BRI Interface
During the configuration, ensure "000" emergency number is not barred, by performing the following:

Short Code: "000"

Telephone No.: "000;"

Function: "Dial Emergency"

Connections to TS013, the following Bearer Capabilities shall not be used:

7kHz Audio

Video

Restricted Digital Information

If unknown type of number is used in calling party number, the network will use the default CLI.
The system must be configured for Point to Multi point connection to comply with Austel requirements

for connecting to TS013 circuits.
As the IP Office does not support emergency dialing after loss of power, the following warning notice

should be recognized:

WARNING

This equipment will be inoperable when mains power fails.

PRI Interface
During the configuration, ensure "000" emergency number is not barred, by performing the following:

Short Code: "000"

Telephone No.: "000;"

Function: "Dial Emergency"

WARNING

This equipment will be inoperable during mains power failure.

IP Office Operation in Canada

Industry Canada Notification (DoC)

This equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications.

This is confirmed by the registration number. The abbreviation, IC, before the registration number

signifies that registration was performed based on a Declaration of Conformity indicating that Industry

Canada technical specifications were met.
It does not imply that Industry Canada approved the equipment.
''NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is 1. The REN

assigned to each terminal equipment provides an indication of the maximum number of terminals

allowed to be connected to a telephone interface. The termination on an interface may consist of any

combination of devices subject only to the requirement that the sum of the Ringer Equivalence

Numbers of all the devices does not exceed five.''

Page 8 - Safety and Homologation Statements

IP Office Installation Manual

Regulatory Instructions for Use

40DHB0002USCL – Issue 7 (09/25/2002)

Advertising