Allied Telesis AT-S63 - Manual (Page 123)

AT-S63 Management Software Features Guide
Section I: Basic Operations 123
Configuring the Feature
Here are the commands that are used to configure the link-flap protection
feature. The first example uses the standard commands and the second
example uses the AlliedWare Plus commands. They configure the feature
such that link-flap events are defined as seven link changes in three
minutes, and they activate the feature on ports 11 to 20. To configure this
example from the standard commands, you would enter:
set link-flap rate=7 duration=180
add link-flap port=11-20
enable link-flap
show link-flap
To use the AlliedWare Plus commands, you would enter:
awplus> enable
awplus# configure terminal
awplus(config)# link-flap rate 7
awplus(config)# link-flap duration 180
awplus(config)# interface 11-20
awplus(config-if)# link-flap protection
awplus(config-if)# end
awplus# show link-flap