Allied Telesis AT-S63 - Manual (Page 143)

AT-S63 Management Software Features Guide
Section II: Advanced Operations 143
Observe this guideline when using these criteria:
 The Protocol variable must be left blank or set to IP.
TCP Source Ports (Layer 4)
TCP Destination Ports (Layer 4)
A traffic flow can be identified by a source and/or destination TCP port
number contained within the header of an IP frame. Observe the following
guidelines when using these criteria:
 The Protocol variable must be left blank or set to IP.
 The IP Protocol variable must be left blank or set to TCP.
 A classifier cannot contain criteria for both TCP and UDP ports. You
may specify one in a classifier, but not both.
UDP Source Ports (Layer 4)
UDP Destination Ports (Layer 4)
A traffic flow can be identified by a source and/or destination UDP port
number contained within the header of an IP frame. Observe the following
guidelines when using these criteria:
 The Protocol variable must be left blank or set to IP.
 The IP Protocol variable must be left blank or set to UDP.
 A classifier cannot contain criteria for both TCP and UDP ports. You
may specify only one in a classifier.
TCP Flags
A traffic flow can be based on the following TCP flags:
 URG - Urgent
 ACK - Acknowledgement
 RST - Reset
 PSH - Push
 SYN - Synchronization
 FIN - Finish
Observe the following guidelines when using this criterion:
 The Protocol variable must be left blank or set to IP.
 The IP Protocol variable must be left blank or set to TCP.
 A classifier cannot contain both a TCP flag and a UDP source and/or
destination port.