Aiphone 83873900 0602 E - Manual (Page 25)

– 25 –
4. MOUNTING
Ⅵ Mounting NHX-50M master station
As shown, NHX-50M can be wired to NHX-80X CCU, using terminal cord supplied.
At NHX-50M end, plug in 10-pin connector.
Ⅵ Assembling two Consoles: NHX-50M & NHX-30G
On the bottom of the NHX-50M, cut off the socket part and plug 2 connectors from the NHX-30G into the
socket. Mount the cover at 3 points, which connects NHX-50M & NHX-30G units together.
To; CN1 Socket on
back of NHX-50M
10-pin plug
Terminal cord
6'7"(2m) long approx. Wire nuts
NHX-80X
cable
As shown, connect 10 lead-wires with wire nuts.
Make sure the wire terminations will not be pulled
or crushed.
10-pin plug-in socket
CN1
Cable clamp
Cable clamp
to NHX-80X
CCU
Terminal cord, approx. 6' 7" (2m)
NHX-50M
Chassis back view
To connect NHX-30G;
Cut off this part with a
cutter.
Yellow
Yellow
NHX-30G
NHX-50M
CN3
CN2