Alpine CVA-1003R - Manual (Page 10)

8
-EN
Basic Operation
MUTE OPEN/CLOSE
ANGLE
77777 88888
MODE/LOUD
Lowering the Monitor
1
Press the OPEN/CLOSE button.
The unit will beep 3 times and lower the monitor
automatically.
NOTES
• The CVA-1003R is a precision device. With gentle
handling, its unique capabilities can be enjoyed for a
long time.
• If the monitor touches an obstacle while it is being
lowered, the unit will stop lowering the monitor
immediately.
Should this occur, remove the obstacle and press the
OPEN/CLOSE button again to lower the monitor.
Selecting the Monitor's Opening
Position
The monitor's opening position has 2 settings.
1
Press and hold the OPEN/CLOSE button for at
least 2 seconds while the monitor is being raised.
Each press changes the monitor position back or
forth.
Adjusting the Monitor Viewing
Angle
Adjust the monitor's angle for better visibility.
1
Press the ANGLE
77777 88888 buttons to adjust the
monitor's angle so the screen will be in the best
viewing position. Each press of the buttons
produces a beep and changes the screen angle
between 40 and 105 degrees.
When you press and hold the
77777 or 88888 (ANGLE)
button for at least 2 seconds, the monitor's angle
keeps moving until you release the button.
NOTES
• If the monitor touches an obstacle while the angle is
being adjusted, the unit will stop the screen
immediately.
Should this happen, remove the obstacle and press the
ANGLE
7 or 8 button again.
• The screen colour will vary when viewed at certain
angles. Adjust the screen angle for the best viewing
position.
• If the voltage of the vehicle's battery power is low, the
screen may blink when the screen angle is changed.
This is normal and not a malfunction.
CAUTION
Keep hands (or any other object) away from the display
while it is opening or closing to avoid damage or injury.
The back of the movable display will get very warm
under normal operating conditions. This is not a
malfunction. Do not touch.
77777 88888