Alpine CVA-1003R - Manual (Page 24)

22
-EN
CD Player/Changer Operation (Optional)
3
The CD Changer Selection mode remains active
for 3 seconds after step 2 is performed. Press
the BAND button until the desired CD Changer
indicator appears on the display.
NOTE
If the selected CD Changer is not connected, the display
will show "NO CHANGER."
Alternatively press the BAND button on the
Remote Control until the desired changer
indicator appears on the display.
4
To operate the selected changer, see "CD Player
Operation" section.
NOTE
If an optional CD/MD/DVD player is connected to the
unit, the disc mode can be switched each time you press
the BAND button (see "Switching Disc Mode" on page
41).
Multi-Changer Selection
Alpine's Ai-NET system will support up to 6 CD
Changers. When operating two or more changers,
the KCA-400C (Multi-Changer Switching device)
must be used. If you use 1 Switching device, you
can connect up to 4 CD Changers. If you use 2
Switching devices, you can connect up to 6 CD
Changers.
1
Press the SOURCE button on the CVA-1003R to
activate the CD Changer mode.
Alternatively, press the SOURCE button on the
Remote Control (optional) to activate the CD
Changer mode. Proceed to step 3 below to
select the desired CD Changer.
2
Press the BAND button on the CVA-1003R or
the Remote Control to activate the CD Changer
Selection mode.
SOURCE
BAND