AccuTemp EVOLUTION GAS STEAMER - Manual (Page 26)

MP4010-1003 EVOLUTION GAS STEAMER
20
CLEANING - CONNECTIONLESS
DAILY CLEANING
Turn the steamer off and wait for the steamer to cool. 1.
Open the drain valve and allow the cooking chamber to drain completely. Remove the 2.
pan rails (Fig. 17) and steam collector. Wipe the inside of the cooking chamber, water
sensors, pan rails and steam collector with a clean cloth. Clean the door gasket, inside of
door and front face of the cooking chamber.
Install the steam collector and pan rails. Once the water in the drain pan has
3.
sufficiently cooled empty the drain pan wipe down and replace . Leave the door open
overnight.
WEEKLY CLEANING
Close the drain valve and add 1 cup (8 ounces or 0.24 liters) of white vinegar to the 1.
cooking chamber and fill with approximately 2½ Gallons of tap water , shut the door and turn
the steamer on.
After 15 minutes, turn the steamer off and allow the steamer to cool. Open the drain valve
2.
and allow the cooking chamber to drain completely.
To rinse close the drain valve, fill with approximately 2½ Gallons tap water , close the
3.
door and start the steamer Cook Mode. Let it run for 15 minutes, turn the steamer off and
allow the steamer to cool. Open the drain valve and allow the cooking chamber to drain
completely.
Remove the pan racks, steam collector and steam distributor for cleaning. Clean the water 4.
sensors with a non-metallic cleaning pad. Wipe the inside of the cooking chamber, water
sensors, pan rails (Fig. 19),steam distributor (Fig. 19), steam collector (Fig. 19).
Install the steam collector first, resting the steam distributor on top of the collector align the 5.
( 4) retaining fasteners and hand tighten and then install the pan rails. Leave door open
overnight.
WARNING
Warning: Do not use a water jet or pressure washer to clean the steamer
OPERATIONS
STEAM
COLLECTOR
STEAM
DISTRIBUTOR
PAN RAIL
Fig. 19