Avocent CCM - Manual (Page 30)

16 CCM Installer/User Guide
group). One or more port groups may then be specified in a user account. A group name may
contain up to eight characters.
Up to 8 port groups may be specified for a CCM850 appliance user, up to 16 port groups for a
CCM1650 appliance user and up to 48 port groups for a CCM4850 appliance user.
For example, assume that ports 1, 2, 3 and 4 are assigned to a group named LINUX. Ports 5, 6, 7
and 8 are assigned to a group named ROUTERS.
Users who must be able to access all Linux devices can be granted this right by having the LINUX
group specified in each of their user accounts. Those users will be able to access the devices
connected to ports 1, 2, 3 and 4.
Users who must be able to access Linux and router devices can be granted this right by having both
the LINUX and the ROUTERS groups specified in their user accounts. Those users will be able to
access the devices connected to ports 1 through 8.
To configure TD=console serial port settings:
Issue a Port Set command. You may specify settings for one port, multiple ports or all ports.
PORT [<port>|ALL] SET TD=CONSOLE [NAME=<name>] [BAUD=<baud>]
[SIZE=<size>] [PARITY=<parity>] [STOP=<stop_bits>] [FLOW=<flow_ctrl>]
[TIMEOUT=<time-out>] [SOCKET=<socket>] [CHAR=^<cli_char>]
[TOGGLE=NONE|DTR] [POWER=<signal>] [GROUP=<group>]
For more information and descriptions of all valid parameters, see Port Set command on page 61.
To configure TD=SPC ports and settings:
Issue a Port Set command with the TD=SPC parameter.
PORT <port> SET TD=SPC [NAME=<name>] [GROUP=<group>]
When a port is configured for an SPC power control device, you may specify only the Name and
Group parameters; no other serial port settings may be specified with the Port Set command.
However, you may use the SPC command to change certain configuration values for the SPC device.
SPC <port>|ALL [MINLOAD=<amps>] [MAXLOAD=<amps>]
Use an SPC Socket command to configure or control the state of the sockets on the SPC device.
SPC <port>|ALL [SOCKET <socket>] [WAKE=ON|OFF] [ONMIN=<time>]
[OFFMIN=<time>] [POWER=ON|OFF|REBOOT]
For more information, see SPC Command on page 85 and SPC Socket Command on page 85.
NOTE: Users who wish to use the native command interfaces of the SPC device should specify TD=console.
To display serial port settings:
Issue a Show Port command.
SHOW PORT [<port>|ALL|NAMES|GROUPS]
When you request information about a port configured as TD=console, the display includes
configuration information, current power status (if power status monitoring has been enabled), plus