Avocent CCM - Manual (Page 91)

Chapter 5: CCM Appliance Commands 77
If NFS has never been enabled on the appliance, the default values will be displayed. If NFS was
previously enabled and successfully configured, then later disabled, the display will retain the
configured address, mount point and file type values.
Access right: SMON
Access level: ADMIN or APPLIANCEADMIN
Syntax
SHOW NFS
Show NTP command
The Show NTP command displays NTP configuration information.
If NTP has never been enabled on the appliance, the default values will be displayed. If NTP was
previously enabled and successfully configured, then later disabled, the display will retain the
configured address and update values, and the status will remain Success.
If a second IP address was not configured, None will be indicated for that value. If a request for the
time from the first server is successful, the second server’s status will indicate Not attempted.
Access right: SMON
Access level: ADMIN or APPLIANCEADMIN
Syntax
SHOW NTP
Show Port command
The Show Port command displays configuration and status information about one or all ports.
Access right: SMON
Access level: ADMIN or APPLIANCEADMIN
Syntax
SHOW PORT [<port>] [ALL|NAMES|GROUPS|ALERT]
Table 5.29: Show Port Command Parameter
Parameter Description
<port>
A port number, port name or CON. If the port name contains spaces, it must be
enclosed in double quotes.
Default = your port
ALL Displays information about all ports.
NAMES Displays a list of port numbers and associated names.
GROUPS Displays a list of port numbers and the group name assigned to each port (if any).
ALERT Displays a port’s alert strings.