Avocent CCM User Manual
Page 76
62 CCM Installer/User Guide
SIZE=<size>
Number of data bits per character. Valid values are 7 and 8.
Default = 8
PARITY=<parity>
Parity. Valid values are:
None No
parity.
Even
Even parity.
Odd
Odd parity.
Mark
Mark parity.
Space
Space parity.
Default = None
STOP=<stopbits>
Number of stop bits per character. Valid values are 1 and 2.
Default = 1
FLOW=<signal>
Flow control signal. For hardware flow control, be sure the control signals are
correctly wired, or data loss may occur. The flow control signal cannot also be used
for power status monitoring. Valid values are:
XONXOF
Software XON/XOFF flow control.
RTSCTS
Hardware RTS/CTS flow control.
DTRDCD
Hardware DTR/DCD flow control.
None
No flow control.
Default = None
TIMEOUT=<time-out>
Number of time-out minutes in the range 0-90. If no data is received or transmitted
during a Telnet session for the specified period, the session will time-out. A zero
value indicates no time-out. The new value does not affect an active session; it takes
effect in subsequent sessions. This value overrides the time-out value set with a
Server CLI command.
Default = use value set with Server CLI command
SOCKET=<socket>
TCP port that must be entered on the Telnet client to connect to this serial port. The
new value becomes effective in subsequent sessions.
When SSH is enabled, the CCM appliance automatically adds 100 to the specified value.
When All is specified, port 1 will be assigned the specified socket value plus 1, port 2
will be assigned the specified value plus 2, and so on. When All is specified and SSH
is enabled, port 1 will be assigned the specified socket value plus 101, port 2 will be
assigned the specified value plus 102, and so on.
When both plain text Telnet and SSH connections are enabled, the +100 value will
not appear in displays.
This parameter is not valid for the console port.
Default = 3000 plus the port number, 3100 plus the port number if SSH is enabled;
see above for action taken if All is specified
Table 5.11: Port Set Command Parameters (Continued)
Parameter
Description