ADS Technologies Wireless Cable Modem Gateway SBG1000 - Manual (Page 29)

23 SBG1000 User Guide
Home
X
Exit Print
Overview Installation Troubleshooting Contact FAQ Specifications Glossary License
Configuration: Basic Gateway TCP/IP Wireless Print Server USB
Connecting the SBG1000 to the Cable System
1 Be sure the computer is on and the SBG1000 is unplugged.
2 Connect one end of the coaxial cable to the cable outlet or splitter.
3 Connect the other end of the coaxial cable to the cable connector on the SBG1000.
Hand-tighten the connectors to avoid damaging them.
4 If you are using the optional Motorola External Diversity Antenna, install it now. Follow the instructions in
“
Installing the Optional External Diversity Antenna ”.
5 Insert the SBG1000 Installation CD-ROM into the CD-ROM drive.
6 Plug the power cord into the power connector on the SBG1000.
7 Plug the power cord into the electrical outlet. This turns the SBG1000 on. You do not need to unplug it when
not in use. The first time you plug in the SBG1000, allow 5 to 30 minutes to find and lock on the appropriate
communications channels.
8 Check that the lights on the front panel cycle through this sequence:
Turns on when AC power is connected to the SBG1000. Indicates that the power supply is working
properly.
RX Flashes while scanning for the receive channel. Changes to solid green when the receive channel is
locked.
TX Flashes while scanning for the send channel. Changes to solid green when the send channel is locked.
LNK Flashes during SBG1000 registration and configuration. Changes to solid green when the SBG1000 is
registered.
Flashes when the SBG1000 is transmitting or receiving data.
Step 7
Step 2
Step 3
Step 6